Fresh Air Intake Cover

Fresh Air Intake Cover

Removal

- Remove windshield wiper arm.

- Remove the rubber seal - 1 - and remove plenum chamber cover - 2 - by carefully pulling it off retainers on windshield.






Checking

- Ensure fresh air intake cover - B - is installed correctly and is not damaged.






- Remove bolts - A - (tightening torque 2.5 Nm).

- Remove cover - B -.

Installation

Installation is done is reverse order, observe the following:

• Before installing, check bonded seal and cover - B -, replace a damaged seal or cover.

• When installing, ensure cover - B - and accompanying seal are seated correctly. If cover is not installed correctly, water can run into the A/C unit air intake shroud.

• If the fresh air intake cover is damaged, it must be replaced.