Heated Oxygen Sensors Overview

Heated Oxygen Sensors Overview

Connector - 1 - for the Heated Oxygen Sensor (HO2S) (G39) and Oxygen Sensor (O2S) Heater (Z19)





Heated Oxygen Sensor (HO2S) (G39) and Oxygen Sensor (O2S) Heater (Z19) - 1 -





Electrical Connector for the Oxygen Sensor (O2S) after Three Way Catalytic Converter (TWC) (G130) and Heater for Oxygen Sensor (O2S) 1 after Catalytic Converter (Z29) (under the cover)





Oxygen Sensor (O2S) after Three Way Catalytic Converter (TWC) (G130) and Heater for Oxygen Sensor (O2S) 1 after Catalytic Converter (Z29) - 1 -





• The - arrow - in the illustration points in the direction of travel.

• Tightening specifications: 55 Nm

• New oxygen sensors are coated with assembly paste; the paste must not get into slots of oxygen sensor body.

• For a used oxygen sensor, only coat threads with hot bolt paste. This paste must not come into contact with the oxygen sensor slots. Hot bolt paste, refer to the Parts Catalog.

• Always install the oxygen sensor wire in the same location so it does not come into contact with the exhaust pipe.

Heated Oxygen Sensor (HO2S) (G39) and Oxygen Sensor (O2S) Heater (Z19) , removing and installing, refer to => [ Heated Oxygen Sensor (G39) and Oxygen Sensor Heater (Z19) ] Heated Oxygen Sensor (G39) and Oxygen Sensor Heater (Z19).

Oxygen Sensor (O2S) after Three Way Catalytic Converter (TWC) (G130) and Heater for Oxygen Sensor (O2S) 1 after Catalytic Converter (Z29) , removing and installing, refer to => [ Oxygen Sensor after Three Way Catalytic Converter (G130) and Heater for Oxygen Sensor 1 after Catalytic Converter (Z29) ] Oxygen Sensor After Three Way Catalytic Converter (G130) and Heater For Oxygen Sensor 1 After Catalytic Converter (Z29).