Level Control System Control Module (J792)

Level Control System Control Module (J792)

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1783)

Removing

• The active steering control module (J792) is located in the footwell under the driver seat.

• Before removing control module, read out code using Guided Fault Finding in "Replace control module" function.

- Loosen the driver seat and slide it back with the wires connected.

- Remove the sill panel strip..

- Remove the foot rest..

- Disengage the carpet and support it using a suitable wood block - 6 -.






- Remove nuts - 7 -.

- Remove the nuts - 1 - and remove the ground wire - 2 - from the threaded pin.

- Carefully disconnect the wiring harness clip connection - 3 - from the bracket - 4 -.

- Remove the wiring harness connectors - 3 - from the control module - 8 -.

- Remove the bolts - 5 - from the control module - 8 - and remove the bracket - 4 -.

Installing

Install in reverse order of removal. Note the following:

Follow the sequence when installing the control module:

- Tighten the bracket - 4 - with the bolts - 5 - to the control module - 8 - to 8 Nm.






- Connect the wiring harness connectors - 3 - to the control module - 8 -.

- Carefully slide the wiring harness clip connection - 3 - into the bracket - 4 -.

- Insert the control module with the bracket.

- Connect the ground wire - 2 - to the threaded pin and tighten the nuts - 1 - to 6 Nm.

- Tighten nuts - 7 - to 6 Nm.

- The system must be calibrated if the active steering control module is replaced (J792). Refer to => [ Dynamic Steering Basic Setting ] Dynamic Steering Basic Setting.

Tightening specifications: