3 Pin Relay/Fuse Panel

3 Pin Relay/Fuse Panel

Removing






- Switch off the ignition and remove the ignition key.

- Remove the driver side instrument panel cover.

- Disengage the 3 pin relay/fuse panel by pressing the retaining springs in the - direction of the arrow - and remove the relay/fuse panel - 1 -.

- Unclip the fuse panel on the relay and fuse panel.

- Remove the relay and control modules.






- Release the retaining clips - arrows - and press the relay carrier - 2 - back and out of the bracket - 1 -.

• The exact assignment of the 3 pin relay/fuse panel can be found in the applicable wiring diagram.

Installing

Install in reverse order of removal, observing the following:

- Install the driver side instrument panel cover.