Lane Change Assistance

Lane Change Assistance Control Modules (J769)/(J770)

Removing






- Remove the rear bumper cover.

- Disconnect the electrical connector - 3 -.

- Remove bolts - 2 and 4 -.

- Remove the lane change assistance control module - 1 - from the mount on the bumper.

Installing

Install in reverse order of removal, observing the following:

- Install the rear bumper cover.

If the bumper cover was removed, the lane change assistance control module must be calibrated again. Refer to => [ Lane Change Assistance, Preparing for Calibration ] Lane Change Assistance, Preparing For Calibration.