Fuel System

Fuel System

Note the following when working on the fuel system:

There is a risk of injury because the fuel is under very high pressure.

• Reduce the fuel pressure down to residual pressure before opening high pressure area of the fuel injection system.

• To reduce remaining residual pressure, place clean cloth around the connector and carefully loosen connector.

To prevent personal injury and damage to the injection and ignition system, observe the following:

• Turn off the ignition before disconnecting and connecting the wiring for the injection and ignition system. This includes tester cables as well.

• Wash the engine only when the ignition is turned off.

• If the connectors were disconnected and the engine was started, then malfunctions have been stored in the Engine Control Module (ECM) Diagnostic Trouble Code (DTC) memory: Generate readiness code in Guided Functions using the vehicle diagnostic tester.

Danger of causing damage to the other electronic components when disconnecting the battery.

• Complete the steps for disconnecting the battery.

• Always turn off the ignition before disconnecting the battery.

- Disconnect the battery.