Supercharger Coolant Pipes

Supercharger Coolant Pipes

Special tools, testers and auxiliary items required

• Hose Clamps up to 25 mm Dia. (3094)

• Drip Tray for VAS 6100 (VAS 6208)

• Hose Clip Pliers (VAS 6362)

Removing






- Remove the front engine cover - 1 - upward.

- Remove the front noise insulation - 1 -.













Risk of scalding due to hot steam and hot coolant.

• The coolant system is under pressure when the engine is warm.

• Cover the coolant reservoir cap with a cloth and then open it slowly to release the pressure.

- Open the coolant reservoir cap.

- Place the (VAS 6208) under the engine.

- Disconnect the coolant hoses with the (3094) and remove them from the left front coolant pipes on the supercharger by loosening the clamps - 1 -.






• Ignore - 2 -.

- Remove the bolts - 1 and 2 - and the coolant pipes.






Installing

Install in reverse order of removal. Note the following:

• Tightening specifications, refer to => [ Coolant Pipes Overview ] Coolant Pipes Overview.

• Replace the seals

• Secure all hose connections with hose clamps of the same type as those equipped by the factory, refer to the Parts Catalog.

- Fill with coolant. Refer to => [ Filling ] Service and Repair.

- Install the noise insulation.