Brake System Vacuum Pump (V192), Checking, RS 5

Brake System Vacuum Pump (V192), Checking, RS 5

Description and Function

The electrical vacuum pump is switched on by the engine control module depending on the intake line pressure.

Vacuum pump has On Board Diagnostic (OBD) properties. Detected faults are stored in engine control module.

• The function of the electrical vacuum pump can only be checked using OBD when the engine is switched off.

Special tools, testers and auxiliary items required

• Vehicle Diagnostic Tester (VAS 5051B) or (VAS 5052)






Procedure

- Turn off the ignition.

- Press the brake pedal until there is no more brake assistance - "pump the brake booster empty". The brake pedal becomes hard.

- Connect the vehicle diagnostic tester to the 16-pin diagnostic connector in the vehicle with the ignition switched off.

- Switch on tester - arrow -.






- Turn on the ignition.

- Start the program in the vehicle diagnostic tester.

• The ignition must be switched off and onto repeat the test.