Brake Caliper, Servicing, 1LA/1LJ

Brake Caliper, Servicing, 1LA/1LJ

• Install complete repair kit when servicing.

• Apply thin coat of assembly paste (G 052 150 A2) to brake cylinders, pistons and seals.






1 - Bolt

• 30 Nm

2 - Cap

• Insert in brake caliper.

• Replacing, refer to => [ Protective Cap and Guide Pin, 1LA/1LJ ] Protective Cap and Guide Pin, 1LA/1LJ.

3 - Guide Pins

• Slide through the boot.

• Replacing, refer to => [ Protective Cap and Guide Pin, 1LA/1LJ ] Protective Cap and Guide Pin, 1LA/1LJ.

4 - Cap

• Install on the bleeder valve.

5 - Bleeder Valve

• Apply a thin coat of assembly paste (G 052 150 A2) to the threads before installing.

• 15 Nm

6 - Brake Caliper Housing

7 - Spring

• Ensure installation position is correct.

8 - Cap

• Do not damage when installing piston.

• Coat with Assembly Paste (G 052 150 A2).

9 - Pistons

• First apply thin coat of brake cylinder paste (G 052 150 A2) on piston.

• Diameter 57 mm.

10 - Seal

• Coat with assembly paste (G 052 150 A2).

11 - Brake Carrier

• Removing and Installing, refer to => [ Front Brake Caliper with Brake Carrier ] Front Brake Caliper With Brake Carrier.

• The 4 retaining pins for the brake pads on the brake carrier must not be loosened under any circumstances.

12 - Bolt

• 196 Nm