Accelerator Pedal Module With Throttle Position Sensors

Accelerator Pedal Module with Throttle Position Sensors

Removing






- Remove driver's side lower instrument panel cover.

- Remove driver's side lower instrument panel cover mount - 2 - - arrow -.

- Disconnect electrical connector - 3 -.

- Remove bolts - 1 and 4 - and remove accelerator pedal module.

Installing

• Tightening specification, refer to => [ Accelerator Pedal Module Overview ] Accelerator Pedal Module Overview.

Install in reverse order, paying attention to the following:

- Install driver's side lower instrument panel cover.

If the accelerator pedal module with throttle position sensor or Engine Control Module (ECM) are replaced in vehicles with automatic transmission, the kick-down adaptation must be adapted in Guided Functions using a vehicle diagnostic tester.