Reduced Oil Pressure Switch (F378)

Reduced Oil Pressure Switch (F378)

Special tools, testers and auxiliary items required

• Assembly Tool (T10118)

• Socket 24 mm and Jointed Extension (T40175)

Removing






- Remove the rear engine cover - 2 - upward.

- Remove the noise insulation.

- Disconnect the electrical connector - 2 - using the (T10118).






- Remove the reduced oil pressure switch - 1 - with a (T40175).

• The installation location is shown with the compressor removed.

Installing

Install in reverse order, paying attention to the following:

• Tightening specification, refer to => Oil Filter Housing Overview.

• Replace the seal.