Right Cylinder Head Cover

Right Cylinder Head Cover

Special tools, testers and auxiliary items required

• Engine Bung Set (VAS 6122)

Removing






- Remove ignition coils.

- Remove the cover - arrow -.






- Disconnect the connector - 1 -.






Danger of defects caused by dirt.

• Follow the guidelines for cleanliness when working on the fuel supply system. Refer to => [ Clean Working Conditions ] Clean Working Conditions.

Risk of injury from fuel.

• To reduce fuel pressure, lay cloths around connecting point before opening fuel system and carefully loosen.

- Remove the bolts - arrows -.

- Loosen the union nut - 2 - and swivel the fuel supply line to the side.

- Seal the open lines and connections with clean plugs from the (VAS 6122).








Risk of violating emissions legislation.

• Do not open the hose connection - arrow -.

- Remove the bolts in the following sequence - 12 to 1 - and lay the right cylinder head aside with the crankcase ventilation hose - arrow - connected.

Installing

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to => [ Right Cylinder Head Cover, Tightening Specifications and Sequence ] Cylinder Head Overview.

• Replace the O-ring.

• Replace the cylinder head seal if it is damaged.

• Replace the cylinder head cover bolts when replacing the damaged seal.

• Only remove the plugs or caps after installing the lines.

- Clean the sealing surfaces; they must be free of oil and grease.

- Tighten the right cylinder head cover bolts. Refer to => [ Right Cylinder Head Cover, Tightening Specifications and Sequence ] Cylinder Head Overview.

- Install the fuel supply line.

- Install ignition coils.