Front Door Window Motor: Service and Repair

Window Regulator Motor

Removing

- Door trim removed..

• The power window motor can be removed or installed with the motor or side window in any position.

• Before removing motor, disconnect electrical harness connectors.

- Remove Torx(R) screws - 2 - (T 30) and remove motor - 1 -.






Installation

- When installing, make sure that threaded pins - arrows - engage in inner door plate.

- Slide window regulator motor - 1 - onto threaded pin - 3 - and secure with screws - 2 -.

- Tightening specification 3.5 Nm

• Only switch ignition on after installing motor and connecting wires.

• Then move door window upward to stop and keep pressing switch for window regulator for approximately. 2 seconds longer.

• This position is the base position and the high- and low-running function is activated.