Tire Pressure Monitoring Control Module (J502)

Tire Pressure Monitoring Control Module (J502)

Removing

If control module is replaced, read out coding before removal using Guided Fault Finding in "Replace Control Module" function.

- Remove the upper instrument panel cover on the driver side (knee bar).

- Unclip control module - 1 -.






- Disconnect connector and remove control module.

Installing

Install in reverse order of removal.

- If tire pressure monitoring control module (J502) is replaced, system must be coded. Refer to => [ Tire Pressure Monitoring System Usage, Direct System ] Tire Pressure Monitoring System Usage, Direct System.