Information Electronics Control Module 1 (J794)

Information Electronics Control Module 1 (J794)

Special tools, testers and auxiliary items required

• Radio Removal Tool (T10057)

• Protective Cap For Cable Connector (VAS 6223/9)

- Switch off all electrical consumers.

- Remove the key.

- If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine.

Use the Vehicle Diagnosis, Testing and Information System (VAS 5051B) to do so.

Removing

- Insert the two clips from the (T10057) into the slots on the information electronics control module 1 until they engage. Points on the grip eyelets of tool face outward.





- Remove the information electronics control module 1 from the installation frame.

- Disconnect the connectors from information electronics control module 1.

- Attach the (VAS 6223/9) - 1 - onto the MOST-Bus connector - 2 -.





- Remove the (T10057) by pushing the locking tabs on information electronics control module 1.

Installing

- Connect harness connectors.

- Slide the information electronics control module 1 into the installation frame until it engages.