A/T - Gearbox Malfunction Warning, Unable To Select Gear

37 Gearbox Malfunction warning shown in cluster. Customer is unable to select gear.

37 13 92

2030370/2

February 12, 2013

Supersedes Technical Service Bulletin Group 37 number 12-60 dated August 6, 2012 for reasons listed.





Vehicle Information





Condition

^ Customer complains that the transmission malfunction warning appears in the cluster. Customer is unable to select gear.

^ GFF scan of the vehicle finds fault P070600 (driving position sensor - implausible signal) logged in the transmission control module (diagnosis address 02).

^ The test plan points to the F125 multi-function switch as the cause.

Technical Background

Corrosion on the pins of the multi-function switch and its counterpart can lead to implausible signals.

Production Solution

Not applicable.

Service

1. If fault P070600 (driving position sensor - implausible signal) is logged in the transmission control module, check the pins of the multi-function switch and of the adapter wiring loom (counterpart) for water and corrosion marks.

2. If corrosion is found in the connector, replace the multi-function switch and its adapter wiring loom.





Warranty

All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures Manual. Claims are subject to review or audit by Audi Warranty.





Required Parts and Tools

Additional Information

All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service manuals for the latest information.