Transmission Output Shaft With Splines, Vehicles Without Vibration Damper

Transmission Output Shaft with Splines, Vehicles without Vibration Damper

Special tools, testers and auxiliary items required

• Pulling Hook (T20143)

• Oil Seal Installing Tool (T40239)

• Guide Sleeve (T40239/1)

• Sealing grease (G 052 128 A1)

Procedure

• General repair instructions, refer to => [ Repair Information ] Repair Information.

• Clean working conditions for the automatic transmission, refer to => [ Clean Working Conditions ] Clean Working Conditions.

• Check the vehicle data label or the designation on the rear final drive itself to determine which one is installed in the vehicle. Then select the correct rear final drive repair manual.






- Remove the driveshaft.

- Pry off the dust ring - 1 -.






• The dust ring cannot be removed without destroying it.

- Shaft seal, transmission output shaft with splines, removing.






- Clean the running and sealing surface.

- Coat outer edge of seal with gear oil.

- Mount the (T40239/1) , - 1 - on the transmission output shaft.






- Fill the space between the sealing and dust lip half way with sealing grease (G 052 128 A1).

- Install the shaft seal - 2 - over the guide sleeve - 1 - and onto the transmission output shaft.

• Installed position: The open side of the seal faces the transmission housing.

- Install the shaft seal using the (T40239) , - 1 -. Do not bend the seal.






• Remove the (T40239/1) from the shaft seal carefully so that the sealing lip does not fold over.

- Install a new dust ring - 1 -.






• Check the vehicle data label or the designation on the rear final drive itself to determine which one is installed in the vehicle. Then select the correct rear final drive repair manual.

- Install the driveshaft.