Relay and Fuse Panel In Plenum Chamber E-Box

Relay and Fuse Panel in Plenum Chamber E-Box

Observe notes on contact corrosion => [ Contact Corrosion ] Service Precautions.

Removal

- Turn off the ignition and disconnect the ground cable from the battery. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair.

- Remove the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

- Release the retainer - arrow -, remove the engine control module - 1 - and move it to the side with the wires still connected.

• Disregard item - 2 -.

- Remove the screws - arrows - and remove the cover - 1 - for the right plenum chamber E-box.

- Disconnect the connectors - 1 - and remove the nut - 2 - for the electric wire.

- Open the retainers - arrow - and remove the relay panel and fuse panel - 4 -.

- Remove the nut - 3 - for the electric wire.

- Release the tab - arrow -, push fuse panel A - 2 - to the rear and disengage it from the relay panel - 1 -.

- Open the clip and remove the auxiliary fuse panel - 2 -.

- Open the clips - arrows - and remove the relay - 1 - and the control modules from the relay panels.

- Release the retaining clips - arrows - and press the relay carrier - 3 - back and out of the bracket - 4 -.

- Open the clip - 2 - and remove the connector - 1 -.

Installation

• For the correct tightening specification, refer to => [ Tightening Specification: Relay Panel and Fuse Panel Inside Plenum Chamber E-Box ] Engine Compartment E-Box, Wire Junction, Fuse Holder and Battery Overview and => [ Engine Compartment E-Box, Wire Junction, Fuse Holder and Battery Overview ] Engine Compartment E-Box, Wire Junction, Fuse Holder and Battery Overview.

Install in reverse order of removal. Note the following:

- Install the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

- Connect the battery. Refer to => [ Connecting ] Service and Repair.