Oil Pressure Switch (F22)

Oil Pressure Switch (F22)

Removing

- Remove the rear engine cover - 2 - upward.






• To collect escaping engine oil, place a clean cloth under oil filter housing.






- Disconnect electrical connector - arrow -.

- Remove the oil pressure switch.

Installing

Install in reverse order of removal. Note the following:

• Tightening specifications, refer to => [ Oil Filter Housing and Oil Pressure Switch Overview ] Oil Filter Housing and Oil Pressure Switch Overview.

• Replace sealing ring.

• To prevent oil loss, insert the new oil pressure switch in the connecting pieces immediately.

- Check oil level.