Air Injection Pump: Service and Repair

Secondary Air Injection Pump Motor (V101)

Removing

• During installation, all cable ties must be installed at the same location.

- Remover the right front wheel spoiler - 2 -.






- Remove the right air intake grille from the bottom of the bumper cover.

- Disconnect the electrical connector - 4 - on the Secondary Air Injection (AIR) pump motor (V101).






- Press the release buttons and remove the secondary air hoses - 1 - and - 2 -.

- Remove the nuts - 3 - and the secondary air pump.

Installing

Install in reverse order of removal. Note the following:

• Tightening specifications, refer to => [ Secondary Air Injection System Overview ] Service and Repair.

• Replace O-rings.

- Install the front right wheel spoiler.