Denso A/C Compressor Belt Pulley - Version 1 Overview

Denso A/C Compressor Belt Pulley - Version 1 Overview






1 Sealing Cap

2 Drive Plate

• 30 Nm

• Replace

• Attached to the A/C compressor input shaft.

• The thread of the new drive plate has already been greased with a specific amount of a grease by the manufacturer.

• Different versions, refer to Electronic Parts Catalog.

• The overload protection takes over when the torque is excessive (for example, if the A/C compressor runs with resistance) and the belt pulley runs freely without driving the A/C compressor.

• With rubber elements for decoupling the belt pulley from the A/C compressor input shaft, dampens vibrations and noise.

• Removing and installing, refer to => [ Denso A/C Compressor Belt Pulley - Version 1 ] Denso A/C Compressor Belt Pulley - Version 1.

3 Circlip

• Replace

• Install on the correct side - flat side toward the A/C compressor.

4 Belt Pulley

• Different versions, refer to Electronic Parts Catalog.

• Is made of plastic and is sensitive to impact.

• Removing and installing, refer to => [ Denso A/C Compressor Belt Pulley - Version 1 ] Denso A/C Compressor Belt Pulley - Version 1.

5 A/C Compressor

• Clean the A/C compressor input shaft before sliding on the belt pulley.