Front ABS Wheel Speed Sensor

Front ABS Wheel Speed Sensor

• The sensor ring/rotor is installed in the respective wheel bearing unit and cannot be replaced.

Removing

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1332)

- Raise the vehicle.

- Disconnect the connector on the speed sensor - 1 -.






- Remove bolt - 2 -.

- Remove speed sensor from wheel bearing housing.

Installing

Installation is the reverse of removal, with special attention to the following:

- Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with Polycarbamide grease G 000 650.

- Install the speed sensor.

- Tighten the bolt to 9 Nm.

- Connect the connector to the speed sensor - 1 -.

- Turn the steering completely left and right after installation, making sure the speed sensor wiring has sufficient clearance.

- Lower vehicle.