Zero Position, Slotted Guide Rail Guide, Checking and Adjusting

Zero Position, Slotted Guide Rail Guide, Checking and Adjusting

Checking

Zero position can only be checked when sunroof panel is installed.

- Boot removed.

- Drive back sunroof panel and close again.

- On vehicles with glass panel, slide sliding headliner completely toward rear.

- Close sunroof.

- For a correct zero position, guide pins - 1 - in center on tilting mechanism must align with marking - arrow - on link guide - 2 -.






Adjusting

- Sunroof motor removed.

- Sunroof panel removed

- Push the slotted guide rail on both sides by hand into the zero position.

- Adjust and install the motor in the zero position.