Sun Visor Center Support

Sun Visor Center Support

Special tools, testers and auxiliary items required

• Pry lever (80 - 200)

Removing






- Detach the sun visor at the sun visor center mount and flip to the side.

- Unclip the sun visor center bracket cover - 1 - by sliding the pry lever (80 - 200) only approximately 1 mm under the cap - 2 arrows -.

• If the pry lever (80 - 200) is shoved further underneath, it will then be under the center bearing for the sun visor. At that point, it is not possible to pry off the cover.

- Remove sun visor center mount - 3 - - arrow 4 -.

Installation

Install in reverse order of removal. Note the following:

Information for installation: for example tightening specifications, replacing body parts, refer to => [ Sun Visors Assembly Overview ] Sun Visors Assembly Overview.