Electronically Controlled Damping Overview
Electronically Controlled Damping Overview
1 Driving Profile Selection Switch Module (E592)
• Component location: The driving profile selection switch module is installed in the instrument panel.
2 Electronic Damping Control Module (J250)
• Removing and installing, refer to => [ Electronic Damping Control Module (J250) ] Service and Repair
• Component location: The electronic damping control module is located behind the right luggage compartment side trim panel.
• If the electronic damping control module is replaced, then the control position must be reprogrammed. Refer to => [ Programming Control Position using ] Testing and Inspection vehicle diagnostic tester.
• If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module (J759) must be recalibrated. Refer to => [ Calibration Procedure ] Calibration Procedure.
3 Shock Absorber with Right Rear Dampening Adjustment Valve (N339)
• Removing and installing, refer to => [ Shock Absorber ] Shock Absorber
• Removing and installing, refer to => [ Shock Absorber ] Shock Absorber
4 Left Rear Level Control System Sensor (G76) and Right Rear Level Control System Sensor (G77)
• Removing and installing, refer to => [ Level Control System Sensor ] Rear Suspension
• If the left rear level control system sensor and right rear level control system sensor were removed and installed or if the linkage was loosened, the control position must be reprogrammed on vehicles with electronically controlled damping => [ Programming Control Position using ] Testing and Inspection vehicle diagnostic tester
• If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module (J759) must be recalibrated => [ Calibration Procedure ] Calibration Procedure.
• On vehicles with automatic headlamp range control system, perform a basic setting on the headlamps.
5 Rear Body Acceleration Sensor (G343)
• Removing and installing, refer to => [ Rear Body Acceleration Sensor (G343) ] Service and Repair
6 Shock absorber with Left Rear Dampening Adjustment Valve (N338)
• Removing and installing, refer to => [ Shock Absorber ] Shock Absorber
• Removing and installing, refer to => [ Shock Absorber ] Shock Absorber
7 Left Front Body Acceleration Sensor (G341) and Right Front Body Acceleration Sensor (G342)
• Removing and installing, refer to => [ Left Front Body Acceleration Sensor (G341) and Right Front Body Acceleration Sensor (G342) ] Service and Repair
8 Shock Absorber with Left Front Dampening Adjustment Valve (N336)
• Suspension strut, removing and installing, refer to => [ Suspension Strut with Mounting Bracket ] Suspension Strut With Mounting Bracket
• Installing the suspension strut, refer to => [ Suspension Strut and Mounting Bracket ] Front Suspension
9 Left Front Level Control System Sensor (G78) and Right Front Level Control Sensor (G289)
• Removing and installing, refer to => [ Level Control System Sensor ] Level Control System Sensor
• If the left front level control system sensor and right front level control system sensor were removed and installed or if the linkage was loosened, the control position must be reprogrammed on vehicles with electronically controlled damping. Refer to => [ Programming Control Position using ] Testing and Inspection. See vehicle diagnostic tester
• If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module (J759) must be recalibrated. Refer to => [ Calibration Procedure ] Calibration Procedure.
• On vehicles with automatic headlamp range control system, perform a basic setting on the headlamps.
10 Shock Absorber with Right Front Dampening Adjustment Valve (N337)
• Suspension strut, removing and installing, refer to => [ Suspension Strut with Mounting Bracket ] Suspension Strut With Mounting Bracket
• Installing the suspension strut, refer to => [ Suspension Strut and Mounting Bracket ] Front Suspension