Suspension Control Module: Service and Repair

Electronic Damping Control Module (J250)

Removing

The electronic damping control module is located behind the right luggage compartment side trim panel.

- Turn off all electrical consumers.

- Remove the key.

- Remove the cover from the right luggage compartment storage compartment.

- Release and disconnect the connector - 3 -.






- Press the clips - 2 - to the side and remove the electronically controlled damping control module - 1 -.

Installing

Installation is the reverse of removal, with special attention to the following:

- Adapt the electronic damping control module. Refer to => [ Programming Control Position using ] Testing and Inspection. Vehicle diagnostic tester.