Front ABS Wheel Speed Sensors

Front ABS Wheel Speed Sensors

• The sensor ring/rotor is installed in the respective wheel bearing unit and cannot be replaced.

Removing

- Raise the vehicle.

- Release connector - 1 - on speed sensor and disconnect.






- Remove bolt - 2 -.

- Remove speed sensor from wheel bearing housing.

Installing

Installation is the reverse of removal, with special attention to the following:

- Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with Polycarbamide grease G 000 650.

- Turn the steering completely left and right after installation, making sure the speed sensor wiring has sufficient clearance.

- Lower vehicle.