Roof Trim

Sun Visor Center Support

Special tools, testers and auxiliary items required

• Pry Lever (80 - 200)

Removing






- Disengage the sun visor in the center of the vehicle at the center bracket and fold it to the side.

- Unclip the sun visor center bracket cover - 1 - by sliding the (80 - 200) only approximately 1 mm under the cap - 2 arrows -.

• If the (80 - 200) is shoved further underneath, it will then be under the center bearing for the sun visor. At that point, it is not possible to pry off the cover.

- Remove sun visor center bracket - 3 - - arrow 4 -.

Installing

Install in reverse order of removal. Note the following:

• Make sure the expanding clips are not damaged when inserting the sun visor center bracket.