Lock Button on Handle For Selector Lever, Attaching

Lock Button on Handle for Selector Lever, Attaching

Special tools, testers and auxiliary items required

• Removal Tool (T40203)

Procedure

• The locking button - 1 - projects out in its installation position in the handle.






• If the locking button was pressed in, then it must be brought back to it installation position so that the handle can be installed.

- Carefully install the (T40203) all the way into the handle - 1 -.






• The handle is shown without the selector lever boot.

• The cut-out on the (T40203) faces the locking button and the hook toward the left.

- Hold handle - A - for the selector lever and turn the (T40203) 180° - arrow 1 -.






- Hold the handle tight and carefully remove the (T40203) - arrow 2 -.

• While the (T40203) is being removed, the locking button - A - on the handle will be pushed out and will lock.






• Do not touch the locking button anymore before installing the handle so that the button does not fall back in.