Suspension Control Module: Service and Repair

Electronic Damping Control Module

• The electronic damping control module (J250) is installed under the right front seat.

Removing

- Remove the right front seat.

- Remove the right sill panel.

- Fold up the carpet.

- Remove the control module - 1 - from its holder - arrows -.






- Disconnect the connector - 1 - from the control module - 2 -.

Installing






Installation is the reverse of removal, with special attention to the following:

- First insert - 1 - the control module into the corners - 3 and 4 - at the back of the holder and then clip it in at the front - arrows -.

- If the electronic damping control module is replaced, the control position must be reprogrammed.

- Adapt the control position. Refer to => [ Control Position Entry, Reprogramming with ] Testing and Inspection.