Steering Gear Overview, Generation I and II

Steering Gear Overview, Generation I and II






1 Universal Joint

2 Bolt

• 20 Nm + 90° turn

• Always replace if removed.

3 Electrical Wiring

4 Steering Gear

• There are different versions. Refer to the Electronic Parts Catalog (ETKA).

• With power steering control module (J500).

• Can be tested in "Guided Fault Finding" using the vehicle diagnosis, testing and information system (VAS 5051B).

5 Wheel Bearing Housing

6 Nut

• Applies to all except S3 and RS 3: 20 Nm + 90° turn.

• Applies to S3: first tighten to 100 Nm; then loosen 180° and tighten again to 100 Nm.

• Applies to RS 3: 110 Nm.

• Self-locking

• Always replace if removed.

7 Subframe with Brackets

8 Bolt

• 50 Nm + 90° turn

• Always replace if removed.

9 Clamp with Nuts

• Not installed on vehicles with Generation III steering gear.

• Removing and installing, refer to => [ Rubber Bushing ] Rubber Bushing.

• Always replace if removed.

10 Heat Shield

11 Bolt

• 6 Nm