Seat Belt Buckle Switch: Service and Repair

Belt Fastening Detection

• The Front Passenger's Seat Occupied Sensor (G128) is only installed on passenger side.

Removing


Follow the safety precautions for pyrotechnic components.

- Remove passenger seat:

• Manual seat, refer to => [ Front Manual Seat ] Front Manual Seat

• Power seat, refer to => [ Power Seat ] Power Seat

• Remove padding only until Front Passenger's Seat Occupied Sensor (G128) - 2 - has been freed up!

- Remove the lower seat frame cover and cushion. Refer to => [ Seat Pan Cover and Upholstery ] Seat Pan Cover and Upholstery





- Remove Front Passenger's Seat Occupied Sensor (G128) connector - 2 -.

- Carefully remove Front Passenger's Seat Occupied Sensor (G128) - 2 - from seat padding - 1 -.

Installation


Follow the safety precautions for pyrotechnic components.

Installation is in reverse order of removal, noting the following:

- Position circuit board - 4 - from Front Passenger's Seat Occupied Sensor (G128) - 2 - in cut-out - 3 - in seat padding - 1 -.





- Align Front Passenger's Seat Occupied Sensor (G128) - 2 - on seat padding - 1 - as shown in illustration.

- Remove protective foil and adhere Front Passenger's Seat Occupied Sensor (G128) - 2 - to seat padding - 1 -.