Front Airbag Crash Sensor

Front Airbag Crash Sensor

Removing and installing


• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.





1 Front Airbag Crash Sensor

• I - Driver's Front Airbag Crash Sensor (G283)

• II - Front Passenger's Front Airbag Crash Sensor (G284)

Removing

- Open hood.

- Disconnect the battery ground wire with the ignition off.

- Disconnect electrical connector on crash sensor.

- Remove bolts - 2 - (quantity: 2).

- Remove front airbag crash sensor.

Installation

To install, perform the steps used in removal in reverse order. Note the following:


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.

2 Screws

9 Nm

• Quantity: 2