Charge Air Pressure Sensor and Intake Air Temperature Sensor

Charge Air Pressure Sensor and Intake Air Temperature Sensor

Removing

- Remove the noise insulation - 1 -.





- Loosen the hose clamp - 2 -, lift the retaining clamp - 1 - and remove the air guide hose.





- Remove bolts - arrows -.





- Free up the coolant hose - 3 -.

- Loosen the hose clamp - 2 -.

- Disconnect the connector - 1 - on the charge air pressure sensor (G31) and then remove the front air guide pipe.

- Remove the screws - arrows - and pull the charge air pressure sensor/intake air temperature sensor (G42) off the air guide pipe.





Installing

• Tightening specifications, refer to => [ Charge Air Cooler Assembly Overview ] Charge Air Cooler Assembly Overview.

Installation is in reverse order of removal, note the following:

• Replace O-ring.

- Install the front air guide pipe. Refer to => [ Charge Air Cooler Assembly Overview ] Charge Air Cooler Assembly Overview.

- Install the noise insulation.