Accelerator Pedal Module With Throttle Position Sensors

Accelerator Pedal Module with Throttle Position Sensors

Special tools, testers and auxiliary items required

• Release Tool (T10238)

Removing

- Remove cover for steering column - arrows -.






Version I

- Disconnect electrical harness connector - 2 -, by pressing release button to the stop - arrow -.






- Where necessary, pull the wiring router - 1 - off from the accelerator pedal module.

Version II

- Disconnect the electrical connector - 2 - on the accelerator pedal module by pulling the release - 1 - up as far as the stop - arrow -.






All Vehicles:

- Pry off the cover using a screwdriver - 4 - => [ Cap ] Accelerator Pedal Mechanism Assembly Overview.

- Remove the bolt - 5 - => [ Bolt ] Accelerator Pedal Mechanism Assembly Overview.

- Push the (T10238) into the intended openings - arrow - up to the stop, as shown, and remove the accelerator pedal module.






Installing

• Tightening specifications, refer to => [ Accelerator Pedal Mechanism Assembly Overview ] Accelerator Pedal Mechanism Assembly Overview.

Installation is in reverse order of removal, note the following:

- Connect the wiring router - 1 - and the electrical connector - 2 - to the accelerator pedal module - 5 -.






• The connector must engage audibly.

- Push the accelerator pedal module onto the securing studs - 6 -.

- Insert centering pin - 7 - into hole on the underbody.

- Secure the accelerator pedal module with the bolt - 3 - and install the cap - 4 -.

A02250352921-050310