Oil Level Sensor: Service and Repair

Oil Level Thermal Sensor

Removing

- Drain engine oil.

- Disconnect the connector - 3 -.





- Remove the bolts - 1 - and the oil level thermal sensor (G266) - 4 -.

Installing

• Tightening specifications, refer to => [ Oil Pump, Oil Pan and Balance Shaft Module Assembly Overview ] Oil Pump, Oil Pan and Balance Shaft Module Assembly Overview.

Installation is in reverse order of removal, note the following:

• Replace the seal - 2 - and the self-locking bolts - 1 -.

- Fill engine oil and check oil level.