Rear Suspension, Front Wheel Drive (FWD)

Diagonal Braces

Special tools, testers and auxiliary items required

• Torque Wrench 5-50 Nm (V.A.G 1331)

• Torque Wrench 40-200 Nm (V.A.G 1332)

Removing






- Remove bolts - 1 - through - 4 - and remove diagonal braces.

Installing

Install in reverse order of removal. Note the following:

• The contact surfaces on the diagonal braces must have any wax on them.

Tightening specifications, refer to => [ Subframe, Diagonal Brace, Lower Transverse Link, Upper Transverse Link, Tie Rod and Level Control System Overview ] Subframe, Diagonal Brace, Lower Transverse Link, Upper Transverse Link, Tie Rod and Level Control System Overview.