Transmission Oil Cooler

Transmission Oil Cooler

Special tools, testers and auxiliary items required

• Hose Clamps Up to 25 mm Dia. (3094)

• Engine Bung Set (VAS 6122)

Removing

Risk of burning due to hot steam and hot coolant.

• When the engine is warm, the cooling system is under pressure.

• Reduce pressure by covering coolant expansion tank cap with cloths and carefully opening.

- Open coolant expansion tank cap.

- Remove the air filter housing.

- Mark the coolant hoses to the transmission fluid cooler to prevent them from being switched when installing.






- Clamp off coolant hoses on transmission oil cooler with (3094) and remove from cooler - A -.

- Seal any open lines and connections with a clean plug from the (VAS 6122).

- Remove bolts - A -.






- Remove transmission oil cooler - B - with both O-rings - C - from transmission.

Coolant must not drip into transmission!

Installing

Install in reverse order, paying attention to the following:

• Tightening specification, refer to => [ Transmission Fluid Cooler and Filter Overview ] Transmission Fluid Cooler and Filter Overview.

• Replace transmission oil cooler bolts.

• Replace O-rings.

- Install the air filter housing.

- Transmission fluid level, checking and filling, refer to => [ Transmission Fluid, Checking and Filling ] Transmission Fluid, Checking and Filling.

- Check status of coolant.