Selector Mechanism Overview
Selector Mechanism Overview
• Coat the bearing areas and sliding surfaces with polycarbamide grease. Refer to the Electronic Parts Catalog (ETKA).
1 Bracket
• For selector lever cable
2 Bolt
• 20 Nm plus an additional 90° turn
• Replace
• Quantity: 2
3 Circle
• Replace
4 Bolt
• 13 Nm
5 Securing Plate
• Replace
6 Selector Lever Cable
• Do not bend
• Do not lubricate the cable eye
• Replace the selector lever cable boot if damaged.
• Removing and installing, refer to => [ Selector Lever Cable ] Selector Lever Cable
• Adjusting, refer to => [ Selector Lever Cable, Adjusting ] Selector Lever Cable, Adjusting
7 Nut
• 8 Nm
• Quantity: 4
• Selector mechanism to the body
8 Stop Buffer for Selector Lever
• Clipped into the selector mechanism
9 Selector Mechanism Function Unit
• With a permanent circuit board for the selector mechanism
• With integrated selector lever sensor system control module (J587) with selector lever (E313) , tipronic switch (F189) , selector lever park position lock switch (F319) and selector lever solenoid (N110).
• Check using Guided Fault Finding in the vehicle diagnostic tester.
• With integrated selector lever sensor system control module with selector lever, tipronic switch, selector lever park position lock switch and selector lever solenoid can only be replaced with the mechanism function of the selector mechanism.
• Perform selector mechanism emergency release, refer to => [ Selector Mechanism, Performing Emergency Release ] Selector Mechanism, Performing Emergency Release
• Removing and Installing, refer to => [ Selector Mechanism ] Selector Mechanism
10 Disengaging Spring
11 Bolt
• 3.5 Nm
12 Mounting Pin
13 Bolt
• 3.5 Nm
• Quantity: 4
14 Locking Plate
15 Selector Mechanism Shift Unit
• With seal
16 Nut
• 9 Nm
• Replace
• Quantity: 4
• Self-locking
17 Bracket
18 Lock Washer
• Quantity: 2
19 Securing Plate
• Replace
• For selector lever cable
• Installed position: The angled end faces toward the function unit