Child Seat Tether Attachment: Testing and Inspection

Child Seat Anchorage, Checking Function

To check function, you must install entire belt system, including side trim.

Switching hold function on

• Pull out seat belt as far as the stop.

Correct function

• Belt must retract with a chattering sound.

• If retracting process is stopped, belt cannot be pulled out anymore.

Deactivating

• Belt retraction to about 100 mm remaining.

• The hold function must switch off when there is at least 100 mm remaining. The belt will function normally again.

If the seat belt child seat anchorage does not work, replace the seat belt