Flywheel: Service and Repair

Dual Mass Flywheel

Special tools, testers and auxiliary items required

• Flywheel Retainer (3067)

Removing

To prevent damage to the dual-mass flywheel when removing, bolts - B - must not be removed using an air-powered or impact wrench. Only removing bolts by hand is permitted.

- Mark the dual-mass flywheel to the engine.

- Rotate dual mass flywheel - A - so bolts - B - are centered to the holes - arrows -.






- When removing the bolts - B - make sure the bolt head does not come in contact with the dual mass flywheel - arrows - which would be damaged if the flywheel is turned further.

- Insert the (3067) into the hole in cylinder block - B -.






- Remove the dual mass flywheel.

Installing

Installation is carried out in the reverse order while noting the following:

• For the correct tightening specifications, refer to => [ Transmission Side Sealing Flange and Dual Mass Flywheel Overview ] Transmission Side Sealing Flange and Dual Mass Flywheel Overview.

- Use new bolts.

- Insert the (3067) into the hole in cylinder block - A -.