Seat Occupied Recognition for Passenger Airbag Deactivation

Seat Occupied Recognition Assembly Overview


The passenger occupant detection system service kit is precalibrated and must not be disconnected. The service kit consists of:

• Passive Occupant Detection System Control Module -J706

• Passive Occupant Detection System Pressure Sensor -G452

• Passive Occupant Detection System Mat

• Seat cushion

• Wiring harness between the passive occupant detection system control module J706 and passive occupant detection system pressure sensor G452.


Follow the safety precautions for the seat occupied recognition system, refer to => [ Passive Occupant Detection Sensor Additional Safety Precautions ] Service Precautions.

• The seat occupied sensor is only installed in the front passenger seat.





1 Seat Occupied Recognition Pressure Sensor (G452)

• is part of the seat occupied recognition mat - 6 -

• Removing and Installing, refer to => [ Passive Occupant Detection System ]


Do not disconnect the electrical connector.

2 Seat pan

3 Retaining clip

4 Cushion

• For seat pan

• Do not separate from the seat occupied recognition mat - 6 -

5 Retaining clip

• Do not release

6 Mat

• For seat occupied recognition

• Is a component with the seat occupied recognition pressure sensor (G452)

• Do not separate from the seat pan upholstery - 4 -

• Removing and Installing, refer to => [ Passive Occupant Detection System ]

7 Mount

• Depending on the version

• For Seat Occupied Recognition Control Module (J706)

8 Spreader pin

• For securing the mount to the seat pan

9 Electrical wiring harness

• Do not separate from the seat occupied recognition pressure sensor (G452) and seat occupied recognition control module (J706)

10 Passenger seat position sensor (G554)

• Is a component of the electrical wiring harness - 9 -

• Removing and Installing, refer to => [ Seat Position Sensor, with Seat Occupied Sensor for Passenger Airbag Deactivation ] Seat Position Sensor With Seat Occupied Sensor For Passenger Airbag Deactivation

11 Seat Occupied Recognition Control Module (J706)

• Depending on the version

• Removing and Installing, refer to => [ Passive Occupant Detection System ]


Do not disconnect the electrical connector.

12 Bolt

• 1.5 Nm