Evaporator Vent (G263)

Evaporator Vent (G263)

Removing

- Move the passenger seats as far back as possible.

- Switch off ignition.

- Remove glove compartment.

- Remove the right (passenger) footwell vent. Refer to => [ Right Footwell Vent ] Right Footwell Vent.

- Disconnect the electrical connection - A -.





- Loosen the Evaporator Vent Temperature Sensor- B - from the A/C bracket - C -

- Turn the evaporator vent temperature sensor - B - 180° and remove it from the A/C.

• The Evaporator Vent Temperature Sensor - B - is installed so that the temperature sensor - D - is facing the evaporator. To remove and install it when the air intake housing is installed, it must be turned it its mount 180° out of installation position after loosening or before tightening.

Installing

Installation is carried out in the reverse order, when doing this note the following.

- Loosen the evaporator vent temperature sensor- B - from the A/C bracket - C -.

- Turn the evaporator vent temperature sensor - B - 180° and then mount it in the bracket.

- Install the removed parts in the opposite order.

- Check the Climatronic Control Module (J255) DTC memory and erase any displayed malfunctions if necessary using the Vehicle Diagnosis, Testing and Information System VAS 5051 under "Guided Fault Finding".