Backrest Heating Element, Super Sport Seat

Backrest Heating Element, Super Sport Seat

Removing





- Remove the backrest cover and cushion. Refer to => [ Super Sport Seat Backrest Cover ] Super Sport Seat Backrest Cover.

- Cover, Separating from Upholstery, refer to => [ Super Sport Seat Backrest Cover, Separating from Upholstery ] Super Sport Seat Backrest Cover, Separating from Upholstery.

- Cut the electrical wire - 3 - off directly at the old backrest heating element - 2 -.

• The old backrest heating element remains on the upholstery - 1 - and the new backrest heating element is bonded over it.

Installation

- Adjust the new backrest heating element on upholstery.


• Make sure the new backrest heating element is affixed to the old heating element.

• Remove the protective films in the bonding sequence for the heating element area.

• When removing the protective film, make sure the heating element is not damaged and that it is attached without wrinkles.

- Bond the backrest heating element - 2 - in sequence - B, A, C and D -.





- Route the connecting wires to the individual heating surfaces in the base of the gaps - arrow -.

- Pull the wire - 3 - through the slit in the cushion - 1 -.

Further installation is performed in the reverse order of removal.