Rear Driveshaft Overview

Rear Driveshaft Overview

• General repair information; refer to => [ Repair Information ] Procedures.

• Driveshaft CV joints may only be moved without force and only as far as their stops, which is a 10° angle.

• Do not bend the rear driveshaft; store and transport it fully extended with the center support bracket facing upward.

• Do not make any repairs to the driveshaft.






1 Rear Final Drive 0BN or 0BP

• Identifying and allocating the rear final drive, refer to => [ Rear Final Drive 0BN, 0BP Identification ] Rear Final Drive 0BN, 0BP Identification

• Removing and installing, refer to => [ Rear Final Drive ] Rear Final Drive

• The color markings on the pins and front driveshaft must all line up.

2 O-ring

• Replace

• 25 mm diameter (black) or 28 mm diameter (green)

• Allocation, refer to the Parts Catalog

3 Securing Ring

• Replace

• 25 mm diameter (black) or 28 mm diameter (silver)

• Allocation, refer to the Parts Catalog

4 Driveshaft, Center Support

• Installed location should be free of tension

5 Securing Ring

• Replace

• Diameter: 28 mm

• Color: Silver

6 O-ring

• Replace

• Diameter: 28 mm

• Color: Green

7 Transfer Case

• Assembly overview, refer to => [ Transfer Case Overview ] Transfer Case Overview

8 Tunnel Brace

9 Bolt

• 60 Nm

• Quantity: 6

10 Bolt

• 20 Nm

• Quantity: 2

11 Rear Driveshaft

• Removing and installing, refer to => [ Rear Driveshaft ] Rear Driveshaft

• The color marking on the rear driveshaft must line up with the color marking on the transfer case and rear final drive.

Installed Position of the Tunnel Support





• The round hole - arrow - on the tunnel side faces the direction of travel.