Glove Compartment Unlock Motor (V327)

Glove Compartment Unlock Motor (V327)

Removing






- Remove the glove compartment. Refer to => [ Glove Compartment ] Glove Compartment.

- Disconnect the connector - 1 -.

- Unscrew the screws - arrows - and remove the glove compartment unlock motor with the cover.

- Remove control cable - 3 - with the adjustment nut from the control cable bracket.






- Slide cover - 2 - off of the glove compartment unlock motor - 1 -.

- Turn cable - 3 - and press retaining bolts - 2 - out of operating rod - 1 -.






- Remove cable.

Installation

Installation is reverse of removal, but note the following:

- Adjust the glove compartment cover control cable. Refer to => [ Glove Compartment Cover Control Cable, Adjusting ] Glove Compartment Cover Control Cable, Adjusting.

• Tightening specifications, refer to => [ Glove Compartment and Instrument Panel Cover, Passenger Side Overview ] Glove Compartment and Instrument Panel Cover, Passenger Side Overview.