Terminal 30 Wire Junction 2 (TV22)

Terminal 30 Wire Junction 2 (TV22)

Removing

- Switch the ignition off.

- Disconnect the ground cable (GND) from the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.






- Remove the seal - 3 -.

- Remove the clips - 1 - from the mounts and remove plenum chamber cover - 2 -.

- Release the retainer in the direction of - arrow A - and open the cover in the direction of - arrow B -.






- Remove the electrical wires - 1 through 6 - and - 9 and 10 -.






- Remove the bolt - 8 - and remove the terminal 2 wire junction 30 from the strut tower.

• Disregard item - 7 - in this example.

Installing

• Tightening specification, refer to => [ Tightening Specifications for the ] Engine Compartment E-Box, Wire Junction, Fuse Holder and Battery Overview.

Install in reverse order.

Connect battery. Required actions, refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.