Interior CAN Cut-Off Connector Mount

Interior CAN Cut-Off Connector Mount

Removing


Danger of unintended engine ignition.

Turn off the ignition and remove the ignition key from the vehicle interior for all work performed on the high voltage vehicle.

- Switch off ignition and remove ignition key.






- Disengage the left A-pillar connector station. Refer to => [ Driver Side A-Pillar 6-Pin Connector Station ] Driver Side A-Pillar 6-Pin Connector Station.

- Remove the interior CAN cut-off connector (T46i). Refer to => [ Interior CAN Cut-Off Connector ] Interior CAN Cut-Off Connector.

- Slide the locking lever - 2 - into the open position in the direction of the - arrow -.

- Press the release - 1 - and press the mount - 3 - for the interior CAN cut-off connector back.

Installing






Install in reverse order of removal, observing the following:

- Slide the locking lever - 1 - on the mount into the closed position.

• Both markings - arrows - must align.

- Install the interior CAN cut-off connector. Refer to => [ Interior CAN Cut-Off Connector ] Interior CAN Cut-Off Connector.

- Install the left A-pillar connector station. Refer to => [ Driver Side A-Pillar 6-Pin Connector Station ] Driver Side A-Pillar 6-Pin Connector Station.