Body Emblem: Service and Repair

Rear Lid Emblems

• Outer edges of rear lid are used as reference edges.






- Warm vehicle and type designation to room temperature.

- Bonding surfaces must be dry and free from dust and grease.

- Clean outer panel with mineral spirits, treat with silicone remover and rub dry.

- Pull off backing paper and press on characters - 1 -, maintaining pressure for approx. 3 seconds.

- After gluing on, press on lettering further using an application roller.

Dimensional data for Front Wheel Drive






• - a - = 30 mm

• - b - = 26 mm

• - c - = 149 mm

• - d - = 25 mm

• - f - = 151 mm

• - g - = 89 mm

Dimensional data for All Wheel Drive (AWD) vehicles






• - a - = 30 mm

• - b - = 26 mm

• - c - = 149 mm

• - d - = 25 mm

• - e - = 4 mm

• - f - = 151 mm

• - g - = 89 mm