Center Outlet (G191)

Center Outlet (G191)

• The Center Outlet Temperature Sensor is installed only on vehicles equipped with the Basis A/C system.

Removing

- Switch off ignition.

- Remove the radio or the CD changer (depending on the vehicle equipment level).

- Reach through the installation shaft and disconnect the connector - A -.





- Turn the sensor - B - 90° and remove it from the air guide channel leading the center instrument panel vents.

Installing

Installation is carried out in the reverse order, when doing this note the following.

- Check the seal - C - for damage and proper seating.

- Install the removed parts in the opposite order.

- Check the Climatronic Control Module (J255) DTC memory and erase any displayed malfunctions if necessary using the Vehicle Diagnosis, Testing and Information System VAS 5051 under "Guided Fault Finding".